Zögern Sie nicht, uns eine E-Mail mit Ihren Fragen zu senden, auch wenn Sie gerade ein Projekt in Betracht ziehen. Es kostet dich nichts.
Swivel mount body of the actuator in the foundation allows to tilt the platform and follow the car's wheels lifted.
Why should you choose exactly our tippler?
Reason No. 1: The Platform bends itself to follow the wheels of the tilting car. In the solutions which are not tilting (eg scissor jacks) there must occur a side slip of the wheels of the car.
Reason No. 2: Piston rod of the actuator is one piece and thus can be subjected to bending moments as opposed to the telescopic actuators whose piston rods by bending moment quickly lose tightness (telescopic actuators should be used in the full ramp tipplers).
Reason No. 3: Cylinder actuator is suspended articulated in the top (not in the bottom!). The place suspension (swivel) reset the bending moments. From the point of suspension to the platform the bending moment increases linearly. In the solutions supported at the bottom of the actuator, bending moments (aggravating seal) arise during climb, because seal is above the swivel.
Reason No. 4: All actuators are hydraulic synchronized by an adequate system of dividers and are moving simultaneously despite uneven loads.
TIPPLER IS AVAILABLE IN TWO VERSIONS:
9 m version
- platform: length 9 m, width 0.8 m
- lifting height: 1.1 m
- 2 hydraulic actuators
- capacity: 12 t
- used for vehicles weight up to 24 t
- power: 6 kW
18 m version
- platform: length 18 m, width 0.8 m
- lifting height: 1.1 m
- 4 hydraulic actuators
- capacity: 24 t
- used for vehicles weight up to 48 t
- power: 11 kW
The tippler is made as assembly of 2 platforms (each length 9m). Hydraulic control enables work of each platform separately or simultaneously. The control system of actuators provides their equal lifting regardless of the load distribution inequality. Implementation of full ramp tippler allows to use telescopic actuators and reduce the depth of excavation into actuators.
